Tektronix AWG710B Manual do Utilizador descarregar pdf (Página 507)

100

101

Appendix B: Performance Verification (AWG710)

AWG710&AWG710B Arbitrary Waveform Generator User Manual B-75

d. Write the DMM reading as a negative voltage.

e. Check that the positive minus negative voltages fall within

2 V ± 0.042 V.

9. Do the following substeps to change the connection to check the CH1

a. Push the CH1 output button.

b. Disconnect the adapter, terminator and cable from the CH1 output

connector.

c. Connect the adapter, terminator, and the cable (removed in step b) to the

CH1

output connector.

d. Push the CH1

output button to turn on the CH1 LED.

10. Repeat the Check Amplitude Accuracy procedure for the AWG710 Arbitrary

Waveform Generator CH1

beginning on page B-72.

11. Reconnect the test hookup on the CH1

output to the CH1 output.

Retain the control settings.

Check Offset Accuracy

The following procedure checks the Offset Accuracy.

1. Use the test hookup and settings from previous check on page B-72 and B-73.

2. Follow the substeps below to set the AWG710 Arbitrary Waveform Generator

controls and to select the sequence file:

a. Push UTILITY (front–panel)!System (bottom)!Factory Reset

(side)!OK (side).

b. Load the OFFSET.WFM file.

Refer to Loading Files on page B-62 for file loading procedures.

c. Push VERTICAL MENU (front–panel)!Amplitude (side).

d. Push 0, ., 0, 2 and ENTER keys in this order or turn the general purpose

knob to set the amplitude to 0.020 V.

3. Push the RUN and CH1 output buttons.

The LEDs above the RUN button and CH1 output connector are on.

1 2 ... 502 503 504 505 506 507 508 509 510 511 512 ... 579 580

Comentários a estes Manuais

Sem comentários

Tektronix AWG710B Manual do Utilizador Página 507

Comentários a estes Manuais

Manuais e produtos relacionados com Geradores de energia Tektronix AWG710B