Tektronix P H A S E R Phaser 840 Manual do Utilizador descarregar pdf (Página 15)

Connecting Your Printer to a Network

Setup Guide

PhaserShare Series B Token Ring card

The PhaserShare Series B Token Ring port conforms to the IEEE 802.5 standard.

With the PhaserShare Series B Token Ring card, you can connect the printer

directly to a Token Ring network using shielded twisted pair (STP; IBM Type 1)

or unshielded twisted pair (UTP; IBM Type 3) cables. Contact your dealer to

obtain adapters and cables.

To fully comply with EMI speciﬁcations, the use of shielded or screened cables

may be required. “Shielded” describes IBM-deﬁned cables used with the DB-9

connector. “Screened” describes cables that are electrically similar to Category

4 UTP, but with an added shield or screen.

When a PhaserShare Series B card is purchased initially with the printer, it is

installed at the factory. When a PhaserShare Series B card is purchased later as

an upgrade kit, follow the installation instructions that are shipped with the

card.

When a PhaserShare Series B Token Ring card is installed in the printer, the

printer’s built-in Ethernet connector is disabled.

To avoid damaging the network interface, turn off the printer before making any

Token Ring connections.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 71 72

Sem comentários

Tektronix P H A S E R Phaser 840 Manual do Utilizador Página 15