Tektronix 200 Series Manual do Utilizador descarregar pdf (Página 33)

EtherTalk Configuration (Macintosh)

User Manual

3-7

Disabling protocols

After your EtherTalk conÞguration is complete, you may want to disable

protocols that you are not using to avoid unnecessary network trafÞc. To

disable protocols, send the appropriate PostScript language Þle to the

printer. The Þles are listed in the following table.

To send the Þles to the printer:

Select the printer in the Chooser.

Locate the appropriate Þle on the Macintosh version of the

printerÕs network utilities diskettes.

The Þles to enable and disable protocols are self-sending.

Double-click on the Þle to send it to the printer.

Reset the printer. (For more information about resetting the

printer, see ÒResetting your printerÓ on page 2-11).

PostScript Þles for enabling and disabling protocols

Protocol To disable protocols To enable protocols

NetWare Disable NetWare Enable NetWare

TCP/IP Disable TCP-IP Enable TCP-IP

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 111 112

Sem comentários

Tektronix 200 Series Manual do Utilizador Página 33