Tektronix TDS1000- Manual do Utilizador descarregar pdf (Página 154)

TDS2CMA Communications Module

136

TDS1000/2000-Series Digital Oscilloscope User Manual

RS-232 Settings

To set up the oscilloscope RS-232 interface, follow these steps:

1. Push UTILITY

" Options " RS-232.

2. Push the option buttons to ma tch the settings of your external

device. The next table lists the settings you can change.

NOTE. The oscilloscope stores these settings until you change them,

even if you push the DEFAULT SETUP button.

Option Settings Comments

Set to

Defaults

Sets the RS-232 interface to factory

defaults (Baud=9600, Flow=hardflag-

ging, EOL String=LF, Parity=None)

Baud 300, 600, 1200,

2400, 4800, 9600,

19200

Sets the data transmission rate

Flow Control Hardflagging, Soft-

flagging, None

Sets data flow control (Softflagging =

Xon/Xoff, Hardflagging = RTS/CTS).

Use hardware flagging when you

transfer binary data

EOL String CR, LF, CR/LF,

LF/CR

Sets the end-of-line terminator sent by

the oscilloscope; the oscilloscope can

receive any EOL string

Parity None, Even, Odd Adds an error check bit (ninth bit) to

each character

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 205 206

Sem comentários

Tektronix TDS1000- Manual do Utilizador Página 154